PENOSIL
Premium Landscaping Adhesive 865 Black foam adhesive for all season use

VALUES

• Great adhesive properties.
• Ideal for securing landscaping blocks.
• Excellent for outdoor use.
• Low curing pressure and post expansion.
• Suitable for all season use, from 41 up to 86 °F.

USAGE INSTRUCTIONS

Shake the can vigorously at least 20 times.

Hold the foam can in upright position, turn the gun to the can by holding the gun handle with one hand, and turn the can with the other hand. Make sure that the gun is not pointed at other persons when turning it. The can must not be screwed to the gun with the valve upside down or by turning the gun on the can.

The foam output can be adjusted by the gun trigger.

Substrate should be moistened as the foam cures due to moisture. A moistened surface ensures better results.

Foam adhesive should be applied to horizontal surfaces. Wait for a few minutes after applying the foam adhesive and then press the stone surfaces together.

Not suitable for distributing or carrying loads.

Foam adhesive can be used to fill narrow voids and cavities.

TIPS

• Air temperature during use: 23°F to 86°F, best results at 68°F.
• Can temperature during application: 41°F to 77°F, best results at 68°F.
• Due to the wide variety of construction materials, we recommend a preliminary compatibility test. Working at low temperatures, the foam can must be prewarmed to room temperature (around 68°F).
• The foam adhesive has sufficient strength for fixing insulation boards. Always follow building design, building regulations, standards or other relevant guidelines concerning additional mechanical fastening when covering insulation boards with cladding materials. Use of insulation support anchors is always recommended.
• Cold foam can has to be warmed with water or air (max. 86°F) before starting work in low temperatures.
• Use Penosil Premium Foam Cleaner 929 to clean tools and surfaces from uncured foam.

LIMITATIONS

• Can should not be exposed to temperature over 122°F, kept near heat sources or in direct sunlight.
• Store upright at 41°F to 86°F.
• Does not adhere to polyethylene (PE), PTFE (Teflon®) or silicone surfaces.
• Cured foam needs to be covered with a suitable material to protect against UV rays.
• In general it is not recommended to use this product on bituminous surfaces. In some cases, e.g. fixing insulation boards on bitumen treated foundations before backfilling, the product has sufficient adhesion. Always test before use.
• Windowsills must have additional constructional support, foam can only be used as an adhesive.