PENOSIL
Fast Foam Adhesive 888

Values

• 2x faster curing time than our other foam adhesives
• Special EasyGun applicator
• Replaces traditional adhesives
• Fast and easy to use
• Solvent-free
• Low VOC
• Excellent adhesion on many materials
• For interior and exterior use

Usage Instructions

Surfaces must be clean from dust, loose particles and oil stains.
Moisten dry surfaces with water mist to ensure a faster curing time and better end results.

Application with foam gun:
Shake the can vigorously at least 20 times. Hold the foam can in an upright position with the valve up.
Hold the foam can adapter in place with your fingers while screwing the gun onto the can. Hold the can upside down when extruding the foam. Foam adhesive output can be adjusted with a gun trigger and adjustment screw.
Do not aim the gun at people. Avoid screwing the gun onto the can with the valve upside down. Do not bend or turn the can during screwing.

EasyGun applicator:
Shake the can vigorously at least 20 times. Remove the cap. Hold the foam can in an upright position with the valve up.
Place the applicator onto the valve, press slightly until the applicator is fixed. Hold the can upside down when extruding the foam.
Foam adhesive output can be adjusted with the applicator trigger.

Installing insulation boards and interior design boards:
Apply the foam adhesive to the board surface in a continuous flow, parallel with the sides of the board (3 to 4 cm from the edge) and one strip in the middle, parallel to the longest side (up to 25 cm between adhesive strips).
After applying the foam adhesive onto the board wait 2 to 3 min and then press the board onto the wall.
The board can be adjusted/straightened during the next 5 min. With one foam can 10m² of wall surface can be covered with insulation boards.

Fixing windowsills:
Before fixing the windowsill, make sure the base surface is levelled. Spacers must be used to support the windowsill; foam can only be used as an adhesive.
Apply foam adhesive to the base surface 3 to 4 cm from the edge.
Weights must be used to fix the windowsill until the foam adhesive is cured.

Tips

• Air temperature during use: +5°C to +30°C.
• Always follow building design, building regulations, standards or other relevant guidelines concerning additional mechanical fastening when covering insulation boards with cladding materials. 
• Use of insulation support anchors is always recommended.
• Consult with a sales agent, a dealer or an architect regarding compatibility with various stone-based materials and other technical issues.
• Due to the wide variety of construction materials, we recommend a preliminary compatibility test. 
• Working at low temperatures, the foam can must be prewarmed to room temperature (around +20°C). 
• Use Penosil Foam Cleaner 929 to clean tools and surfaces from uncured foam. 
• Use Penosil Multipurpose Wipes 943 to clean hands and clothes from uncured foam. 
• Penosil Foam Remover 995 softens cured foam and helps to remove it easier.

More expert tips in FAQ

Limitations

• Does not adhere to polyethylene (PE), PTFE (Teflon®) or silicone surfaces. 
• Do not use at temperatures below +5°C.
• Cured foam adhesive needs to be covered with a suitable material to protect against UV rays. 
• Not recommended for bituminous surfaces. 
• Windowsills must have additional constructional support, foam can only be used as an adhesive.