SpeedFix Seal&Bond PU 860

VALUES

• Fast curing
• Weather and ageing resistant
• For joints up to 40 mm in width
• Good vibration and impact absorption
• Does not sag or create bubbles
• Extremely long service life

USAGE INSTRUCTIONS

Cut the tip of the cartridge. Screw on the nozzle and cut an opening. Place the cartridge onto a sealant gun.

Apply the adhesive by keeping an even pressure at the gun trigger and smoothly dragging the nozzle along the surfaces. 

Immediately press the surfaces together and apply pressure until product is fully cured.

TIPS

• Surfaces must be clean, dry and free from any dust and loose particles. 
• If needed, cover the adjacent surfaces with masking tape. For wide joints, use a backer rod to ensure joints correct thickness and shape. Ensure sufficient ventilation at the working area.
• Due to the wide variety of construction materials, we recommend a preliminary compatibility test. 
• Uncured product can be removed with PENOSIL Multipurpose Wipes 943 or solvent. Cured product can be removed mechanically.
• Application temperature between +5°C and +35°C.

More expert tips in FAQ

LIMITATIONS

• Do not use at temperatures below +5°C.

SAFETY INFORMATION (CLP AND REACH)

DANGER

H334 – May cause allergy or asthma symptoms or breathing difficulties if inhaled.
P101: If medical advice is needed, have product container or label at hand.
P102: Keep out of reach of children.
P261: Avoid breathing dust
P284: Wear respiratory protection.
P304+P340: IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing.
P342+P311: If experiencing respiratory symptoms: Call a POISON CENTER or doctor/physician.
P501: Dispose of the contents and/or its container using the separate collection system in your municipality.
EUH204: Contains isocyanates. May produce an allergic reaction.
Contains Reaction mass of bis(1,2,2,6,6-pentamethyl-4-piperidyl) sebacate and methyl 1,2,2,6,6-pentamethyl-4-piperidyl
sebacate.
Persons already sensitised to diisocyanates may develop allergic reactions when using this product.
Persons suffering from asthma, eczema or skin problems should avoid contact, including dermal contact, with this product.
This product should not be used under conditions of poor ventilation unless a protective mask with an appropriate gas filter (i.e.
type A1 according to standard EN 14387) is used.
As from 24 August 2023 adequate training is required before industrial or professional use.