EasySpray Foam 111

VALUES

• Very low (<0.1%) diisocyanate content
• Excellent air tightness, thermal- and sound-insulation properties
• Enhanced UV resistance
• Quick and easy application
• Excellent adhesion to all common building materials
• Good movement capability
• Thickness of the insulation layer is freely selectable
• Spray applicator compatible with most foam guns
• Interior and exterior use

USAGE INSTRUCTIONS

Surfaces must be clean from dust, loose particles and oil stains.
Moisten dry surfaces with water mist to ensure a faster curing time and better end results.

Attach the spray applicator onto the tip of the foam gun. Shake the can vigorously at least 20 times. Hold the foam can in an upright position with the valve up. Hold the foam can adapter in place with your fingers while screwing the can onto the gun. Hold the can upside down when extruding the foam. Foam output can be adjusted with gun trigger and adjustment screw. Rotate the spray applicator as needed.

Apply the foam from approx. 40 cm distance. One foam layer’s thickness is max. 2 cm. Wait at least 60 min before applying the next layer. Number of layers is not limited. When applying foam in layers, moisten slightly between each layer. Excess foam can be cut off after it has fully cured.

Do not aim the gun at people. Avoid screwing the can onto the gun with valve upside down. Do not bend or turn the can during screwing.

TIPS

• Air temperature during use: +10°C to +30°C.
• Protect adjacent surfaces with paper, plastic film or other suitable material.
• Due to the wide variety of construction materials, we recommend a preliminary compatibility test.
• Working at low temperatures, the foam can must be prewarmed to room temperature (around +20°C).
• Use Penosil Foam Cleaner 929 to clean tools and surfaces of uncured foam.
• Use Penosil Multipurpose Wipes 943 to clean hands and clothes of uncured foam.
• Penosil Foam Remover 995 softens cured foam and helps to remove it easier.

More expert tips in FAQ

LIMITATIONS

• Does not adhere to polyethylene (PE) or PTFE (Teflon®) or silicone surfaces.
• Do not use at temperatures below +10°C.
• Although the cured foam is less sensitive to UV and direct sunlight than other PU foams, it is still recommended to cover it with a suitable opaque material.
• Do not cover before foam has fully cured.
• Spray applicator is compatible with most foam guns. Always check compatibility before choosing the foam gun.

SAFETY INFORMATION (CLP AND REACH)

DANGER

H222 – Extremely flammable aerosol.
H229 – Pressurised container: May burst if heated.
H351 – Suspected of causing cancer.
H362 – May cause harm to breast-fed children.
H413 – May cause long lasting harmful effects to aquatic life.
P101: If medical advice is needed, have product container or label at hand.
P102: Keep out of reach of children.
P210: Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P211: Do not spray on an open flame or other ignition source.
P251: Do not pierce or burn, even after use.
P271: Use only outdoors or in a well-ventilated area.
P280: Wear protective gloves/protective clothing/respiratory protection/eye protection/protective footwear.
P410+P412: Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122°F.
P501: Dispose of the contents and/or its container using the separate collection system in your municipality.
EUH204: Contains isocyanates. May produce an allergic reaction.