PENOSIL
PlasterSeal 650

VALUES

• Ready to use
• No need for joining tapes
• Lightweight
• Non-shrinking, single layer needed
• Quick drying, paintable already after 4 hours
• Very high crack resistance
• Suitable for interior use

USAGE INSTRUCTIONS

Open the bucket, take some product and soften it between two jointing knives before application.

Fill the joints by pressing the filler firmly to the joint with a smaller jointing knife, in a left to right movement.

Remove excess filler with a wider jointing knife in a down to up movement.

TIPS

• Surfaces to be sealed must be stable, even, clean, dry and free from any dust or loose particles.
• Joint between two plasterboards must be around 2 to 4 mm.
• Depending on the humidity and temperature, the drying time is 4 to 6 hours. After drying, it can be sanded, plastered and painted.
• Consumption rate for tapered factory edge and half-rounded tapered factory edge is 0,2 l/m.
• Uncured product can be removed with water. Cured product can be removed mechanically.
• Application temperature between +10°C and +35°C.

More expert tips in FAQ

LIMITATIONS

• Can not be applied on glass, bitumen or on building materials which contain tar, might bleed oils or plasticizers.
• Can not be applied on plasterboards with levelled cut edges or mixed edges.
• Do not cover before product has fully dried.
• Not suitable for exterior use.
• Do not use at temperatures below +10°C.

SAFETY INFORMATION (CLP AND REACH)

EUH208 Contains 1,2-benzisothiazol-3(2H)-one, Reaction mass of 5-chloro-2-methyl-2H-isothiazol-3-one and 2-methyl-2Hisothiazol-
3-one (3:1). May produce an allergic reaction.