PENOSIL
StoneFix 827

VALUES

• Strong adhesive bond in just 30 min
• Fast and easy to use
• Much faster than mortar
• For building non-load-bearing interior walls
• Dust-free
• Very economical
• All-season use (-5°C to +30°C)
• One can equals to 25 kg of mortar
• Application with a foam gun
• Strong and solid structure

USAGE INSTRUCTIONS

Surfaces must be clean from dust, loose particles, ice and oil stains.
Moisten dry surfaces with water mist (only at temperatures above zero) to ensure a faster curing time and better end results.

Shake the can vigorously at least 20 times. Hold the foam can in an upright position with the valve up.
Hold the foam can adapter in place with your fingers while screwing the gun onto the can. Hold the can upside down when extruding the foam. Foam adhesive output can be adjusted with a gun trigger and adjustment screw.

Do not aim the gun at people. Avoid screwing the gun onto the can with the valve upside down. Do not bend or turn the can during screwing.

Foam adhesive can be used for building non-load-bearing interior walls.
The first row of blocks must be well levelled using mortar.
Foam adhesive should be applied to both vertical and horizontal surfaces.
Wait for a few minutes after applying the foam adhesive and then press the stone surfaces together.
Foam adhesive can only be used in case even distribution of loads from block to block is ensured.
Not suitable for distributing or carrying loads.

TIPS

• Air temperature during use: -5°C to +30°C.
• Due to the wide variety of construction materials, we recommend a preliminary compatibility test.
• Working at low temperatures, the foam can must be prewarmed to room temperature (around +20°C).
• Use Penosil Foam Cleaner 929 to clean tools and surfaces from uncured foam.
• Use Penosil Cleaning Wipes 941 to clean hands and clothes from uncured foam.
• Penosil Foam Remover 995 softens cured foam and helps to remove it easier.

LIMITATIONS

• Does not adhere to polyethylene (PE), PTFE (Teflon®) or silicone surfaces.
• Do not use at temperatures below -5°C.
• Cured foam needs to be covered with a suitable material to protect against UV rays.