PENOSIL
White Filling Foam 267 Elastic filling straw foam

VALUES

• Very low (<0,1%) diisocyanate content
• Enhanced UV resistance
• Low curing pressure
• Excellent movement capability
• Excellent air tightness, thermal and sound insulation properties

USAGE INSTRUCTIONS

Surfaces must be clean from dust, loose particles and oil stains. Moisten dry surfaces with water mist (only at temperatures above zero degrees) to ensure faster curing time and better end results. 

Shake the can vigorously at least 20 times. Remove the cap. Hold the foam can in an upright position with valve up. Screw the straw applicator tightly to the foam can valve.

Hold the can upside down when extruding the foam. Foam output can be adjusted with the applicator trigger.

Fill the joints up to approx. 60%. In case of larger joints, apply foam in several layers and moisten slightly between each layer. Excess foam can be cut after it has fully cured.
 

TIPS

• Protect adjacent surfaces with paper, plastic film or other suitable material. 
• Due to the wide variety of construction materials, we recommend a preliminary compatibility test. 
• Working at low temperatures, the foam can must be prewarmed to room temperature (around +20°C). 
• Use Penosil Foam Cleaner 929 to clean tools and surfaces from uncured foam. 
• Use Penosil Cleaning Wipes 941 to clean hands and clothes from uncured foam. 
• Penosil Foam Remover 995 softens cured foam and helps to remove it easier.

LIMITATIONS

• Does not adhere to polyethylene (PE), polypropylene (PP) or PTFE (Teflon®) or silicone surfaces. 
• Do not use at temperatures below +5°C.
• Cured foam needs to be covered with a suitable material to protect against UV rays. 
• Do not cover before foam has fully cured.