PENOSIL
EpoxyFix Plastic 540 Epoxy putty for plastics

VALUES

• Very high binding strength
• Easy to use
• Wate and chemical resistant
• Repairing, restoring, modelling plastic objects
• Extreme temperature resistant
• Isocyanate and solvent free
• Modelling-clay-like consistency, non-sagging
• Quick drying

USAGE INSTRUCTIONS

Cut or twist off a required amount of putty.

Knead it with your fingers until the putty colour is uniform. If kneading is difficult, warm the putty to a room temperature or slightly above. Uniform mixing is important for a good-quality end result.

Apply the putty to the surfaces to be repaired within 2 minutes of mixing. Press the product onto the surface and immediately after application, remove any excess putty with a moistened tool or finger.

When applying the putty to moist, wet or slowly leaking surfaces, press the putty strongly onto the surface and keep the pressure on until it adheres.

After final curing, the putty can be drilled, grinded, sawn, varnished and painted.

TIPS

• In order to achieve a strong and fast adhesion, roughen the surface beforehand with sandpaper or other similar material.
• Surface must be clean and free from any dust or loose particles.
• With moist fingers it is much easier to mix, apply and smoothen the putty.
• Uncured product can be removed with PENOSIL Cleaning Wipes 941 or water. Cured product can be removed mechanically.
• Application temperature +5°C and +30°C.

LIMITATIONS

• Not suitable for general construction works.
• Do not use at temperatures below +5°C.