PENOSIL
Floor&Wall UniversalFix 619

VALUES

• Ready-to-use
• Suitable for underfloor heating
• Fast and strong bonding
• Easy to use
• Low viscosity
• Low VOC, safe to use
• Excellent adhesion on many materials
• Suitable for interior use

USAGE INSTRUCTIONS

Bring the product to room temperature. Open the bucket and stir the mixture.

Always install the floor- or wall-covering materials according to the manufacturer's instructions.

Wet gluing:
Spread the adhesive with a notch trowel onto an area that can be covered within the application time.
Make sure that the whole surface is well covered with the adhesive.
Press the floor- or wall-covering material onto the wet adhesive. Material can be adjusted up to a maximum of 20 minutes.
Use a flooring roller or another suitable tool to ensure maximum adhesion.
Make sure that there are no air bubbles between the surfaces.

Double-sided gluing:
Spread the adhesive with a notch trowel onto an area that can be covered within the application time.
Make sure that the whole surface is well covered with the adhesive.
Press the floor- or wall-covering material onto the wet adhesive.
Separate the surfaces and let the adhesive dry for 5 to 10 minutes, then ress the surfaces strongly together again.
Use a flooring roller or another suitable tool to ensure maximum adhesion.
Make sure that there are no air bubbles between the surfaces.
In humid areas, make sure all flooring joints are well sealed.

Tips

• Surfaces to be adhered must be clean, dry and free from any dust, loose particles and oil residues. Non-porous surfaces should be cleaned with solvent and a clean, non-fluffy cotton cloth. Excess solvent should be removed with a clean cloth.
• Uncured product can be removed with PENOSIL Cleaning Wipes 941 or water.
• Cured product can be removed mechanically.
• It is recommended to prime concrete surfaces or floors made out of levelling compound beforehand.
• Application temperature between +18°C and +25°C.
• Air humidity should not exceed 65% during application.
• Subsurface relative humidity should not exceed 85% to 90% RH.
• Due to the wide variety of construction materials, we recommend a preliminary compatibility test.

More expert tips in FAQ

Limitations

• Not suitable for surfaces in constant contact with water.
• Do not use at temperatures below +5°C.
• Does not adhere to polyethylene (PE), polypropylene (PP) or PTFE (Teflon®).