Window Tape Full Glue +1 External 404

VALUES

• All-season use (up to -10°C)
• Sd value 1.1 m
• Can be applied before or after window and door installation
• Can be plastered and painted
• Double-sided
• Protects building against wind and moisture
• Excellent adhesion on many materials
• Odourless and low VOC product
• UV resistant up to 12 months
• For exterior use

USAGE INSTRUCTIONS

Cut the tape to a desirable length. If the tape is installed in several pieces, account for an extra 5cm of tape for the overlapping joints.

Remove the protective film from the adhesive strip, and starting from the lower part of the frame, glue the tape along the entire perimeter of the frame.

If the window is installed flush with the wall, leave one tape width in reserve in the corners.

If it is installed inwards, leave half the tape width in reserve.

Install the window or door and fill the joint with elastic foam. After it has fully cured, cut the excess foam.

Remove the protective film and press the adhesive side of the tape firmly on the window casing. Pay attention to folding the corners correctly. For an optimal adhesive bond, use a pressure roller.

Tips

• Surfaces to be sealed must be stable, clean, dry and free from any dust, loose particles and oil stains.
• For rough, uneven, porous and other surfaces that might lack sufficient adhesion, it is recommended to prime the surfaces beforehand to improve adhesion.

More expert tips in FAQ

Limitations

• Do not clean the surfaces with chemicals containing substances that impair or reduce tapes' bonding properties.
• Do not use at temperatures below -10°C.
• Not suitable for surfaces in permanent contact with water.
• The tape must be covered with paint, plaster or other covering material as soon as possible, but no later than 12 months after installation.