Usage Instructions
Surfaces must be clean from dust, loose particles and oil stains.
Remove the cap. Hold the foam can in an upright position with the valve up. Screw the straw applicator tightly onto the foam can valve.
To activate the internal cylinder, turn the actuator propeller at the bottom of the cylinder at least 6 times in the direction of the arrow.
Shake the can vigorously at least 30 times for the components to mix. Immediately turn the can upside down and start using the foam.
Foam should have evenly light pink color. If the colour is not even, shake the can again and continue to apply the foam.
Foam output can be adjusted with the applicator trigger.
Do not wait! After turning the propeller, the foam needs to be used up during the next 5 min or it will cure inside the can.
Also, once the system has been activated, heat is released.
If the can is not emptied completely and the temperature inside the can rises above +50°C, there is a risk of explosion.
As the foam expands, fill the joint only partially. In the case of larger joints, apply foam in several layers.
Excess foam can be cut off after it has fully cured.
Always use protective glasses and gloves when working with PU foam!
2K Fire Rated Foam 282 Technical Data Sheet 
