DustProofer 612

VALUES

• Heavy wear-resistant
• Preserves the breathability of concrete
• Dust-repellent
• Oil and chemicals resistant
• Water resistant
• Evenly seals floor's top layer
• Low VOC, safe to use
• Suitable for interior use

USAGE INSTRUCTIONS

The surface is treated in three consecutive stages:

1) Mix the solution with water in a ratio of 1:2
Apply the mix with a soft brush.
Be sure to saturate the surface so that the solution can penetrate into the concrete.
Leave the surface to dry for approximately 40 to 60 min.
Remove the excess product from the surface with a clean cloth.

2) Mix the solution with water in a ratio of 1:1 
Follow the same steps as in stage one.

3) Mix the solution with water in a ratio of 2:1
Follow the same steps as in stage one.

Final drying time is 24 hours.

Tips

• Prior to applying the product, freshly poured concrete surfaces should be left to dry for approximately 21 days (+23°C, 50% RH).
• The best result is achieved by treating previously polished surfaces.
• Surfaces to be treated must be clean, dry and free from any dust or loose particles.
• To achieve a smooth and uniform end result, it is important to remove after the drying time all solution that has not penetrated into the surface. Otherwise, spots may appear.
• When treating the surface in three stages, the product consumption is about 0.5 l/m².
• Clean the tools with water, remove the cured product mechanically.

More expert tips in FAQ

Limitations

• Not suitable for natural stone surfaces (limestone, sandstone).