USAGE INSTRUCTIONS
Surfaces must be clean from dust, loose particles and oil stains.
Moisten dry surfaces with water mist to ensure a faster curing time and better end results.
Shake the can vigorously at least 20 times. Hold the foam can in an upright position with the valve up.
Hold the foam can adapter in place with your fingers while screwing the can onto the gun. Hold the can upside down when extruding the foam. Foam adhesive output can be adjusted with a gun trigger and adjustment screw.
Apply the foam adhesive along the middle of the supporting joists in a continuous flow. Then press the subfloor panel onto adhesive during the next 10 to 15 minutes.
Do not adjusted/lift up the panels, as this can damage the adhesive structure and significantly reduce bond strength.
Once the panels are in place, maintain pressure and secure them with some additional mechanical fixings.
Do not walk on or load the subfloor until the adhesive has fully cured.
With one foam can approx. 128 linear metres (with a 13 mm bead) can be covered with foam adhesive.
Do not aim the gun at people. Avoid screwing the can onto the gun with the valve upside down. Do not bend or turn the can during screwing.
Always use protective glasses and gloves when working with PU foam adhesive!